Victron energy VE.Net DC Manual de usuario Pagina 4

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 6
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 3
VE.Net Connectivity Module
VE.Net Connectivity Module
Power supply voltage
range
7 – 32 V DC
Maximum current
consumption
30 mA / 12 V – 15mA / 24V
Autonomy
24 hours on 2 Internal rechargeable AAA
SENSORS
Battery Voltage (2x) 7,0 – 32,0V ± 5%
Ignition N/C input
Panic alarm N/C input
Auxiliary1 N/C input
Auxiliary2 N/C input
OUTPUTS
Contactor 1A / 30 V DC / 250 V AC / (N/O)
ENCLOSURE
Specics Water resistant
Measurements 13 x 11,8 x 3,5 cm
Weight 275 g
Connector
Deutsch DTM06-12SA for inputs/outputs
RJ45 for VE.Net
ANTENNA GSM AND GPS
Dimensions
64,5mm (D) x 13,6mm (H) with 3m cable
GSM Frequencies 900MHz/1800MHz
STANDARDS
Emission FCC approval pending
Monitor and Request information remotely
The VE.Net Connectivity Module uses GPRS technology to allow
you to remotely monitor and control the VE.Net.
Secure website
The Connectivity Module can be accessed via a secure,
password protected, website that allows easy monitoring and
controlling of all the information available on the VE.Net.
Alarms and notications
All VE.Net alarms are forwarded to the website. The system can
be programmed to send a voice, fax, sms or email notication,
depending on the severity or type of alarm. This way you will
always be in touch!
Inputs and outputs
As well as the VE.Net connection, the gateway also handles the
following sensors and outputs that can be monitored and
controlled remotely:
Sensors
- Voltage measurement (2x) (7-32V)
- Ignition
- Panic
- Auxiliary 1
- Auxiliary 2
- Temperature
Output
- Contactor (normally open)
Power backup
Two internal rechargeable batteries ensure that the gateway
continues to function for up to 24 hours in case of disconnection
from the main power supply.
GPS Functionality
The VE.Net Connectivity Module is equipped with a GPS that
provides position information to the web module. Position
information is dynamically updated on the website and users can
view current position, trace information or, for eet management,
can view multiple devices on a single map. Geofence alarms can
also be programmed.
Vista de pagina 3
1 2 3 4 5 6

Comentarios a estos manuales

Sin comentarios