VE.Net
VE.Net stands for Victron Energy Network.
Remain “in contact”
How convenient would it be if you can always remain ”in
contact”! A low power network that will monitor all
essential equipment and alarms, and keep you informed
through automatic e-mails,
text messages, and even voice
calls. Similarly the wireless connection
could be used to
access all systems on board remotely. If needed
,
a generator could be started, and equipment can be shut
down or powered up. The boat, coach or home could even
be heated or cooled (depending on the climate)
before your arrival.
VE.Net Panel
The VE.Net Panel provides a user interface to all
connected VE.Net devices. This could be one or more
VE.Net Battery Controllers, VE.Net Generator Modules,
regular Victron Energy equipment such as inverters and
the Multi Inverter/Charger combination, or other third
party equipment.
Intuitive user interface
The information available from all the available devices
on the network will be displayed in a simple, easy to read
format. This format will be the same for all connected
devices. Therefore the user only has to become familiar
with one user interface.
Plug and play - no setup needed!
To install the panel you have to connect it to the VE.Net
network with a standard UTP cable. After power up, the
panel searches for all the available VE.Net devices on the
network and automatically loads them.
Alarms
The VE.Net Panel has a buzzer and a set of contacts,
which both can be setup to activate when there is an
alarm on the VE.Net.
User and install mode
To prevent accidental changes in the conguration of the
connected devices, the panel can be set to a “user-only-mode”.
In this mode the panel will hide all the setup menus from
the user.
Remote monitoring and fault nding by a qualied
technician
Electric systems are rapidly becoming more complex,
making it increasingly difcult for the user or a non
qualied technician to identify and correct malfunction.
Enabling remote access to all connected systems by a
qualied technician is the solution. With the help of
VE.Net a technician will be able to remotely access all
systems, change settings and update embedded software
when needed.
Less cabling, less weight, faster and lower cost
installation
Instead of wiring all equipment and lighting to a central
distribution panel, power will be tapped on the spot from a
DC and/or AC busbar. VE.Net enabled DC and AC
switches have been developed for that purpose.
Imagine the savings in cable length and weight that can
be achieved!
VE.Net
Maximum number of
nodes
256
Maximum cable length 100 meter
Network cable Standard UTP with RJ-45 jacks
Network type
Mixed
(star and ring networks possible)
VE.Net Panel VPN
Power supply voltage range 9 - 35 V DC
Current draw - standby 3 mA at 12 volt
Current draw - backlight off 14 mA at 12 volt
Current draw - backlight on 26 mA at 12 volt
Operating temp. range -20 - +50°C (0 - 120°F)
Potential free contacts
3A / 30 V DC / 250 V AC / (N/O)
ENCLOSURE
Measurements front panel
(w x h)
12 x 6,5 cm
(Standard PROS3 Panel)
Measurements body (w x h) 10 x 4,5 cm
Weight 0,1 Kg
VE.Net – the intelligent low power communication network
(84 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales