Victron energy VE.Net DC Manual de usuario descargar pdf (Pagina 8)

Battery Monitor

12.1V 0.0A 99%

DC Voltage

12.10V

Setup Controller

[Press Enter]

Battery Capacity

200Ah

Figure 1

2.3 Setup

When the VE.Net Battery Controller is connected to a VE.Net panel, the panel is powered through

the UTP (Unshielded Twisted Pair) cable.

Step 1.) Hold “Enter” for 2 seconds to power up the VE.Net Panel. After the panel has started with

only the VE.Net Battery Controller connected the screen will display:

The first line shows the name of the connected device, the second line

shows the quick status.

Step 2.) Pres “Enter” to enter the Battery Controller menu.

Step 3.) Press “▼” to scroll through the menu until you see “Setup Controller”.

Step 4.) Press “Enter” to enter the Setup Controller menu.

• Make sure that you first connect the system

before placing the 1Amp inline fuse!

• You should never connect other devices or

wires to the shunt!

• First read the Safety Precautions in

paragraph 1.4

Battery positive

(Load)

Battery

nega

tive

(System ground)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Victron energy VE.Net DC Manual de usuario Pagina 8